AICS 1.5 Stock - Adjust Butt Pad

SiR ELOS · Post by **SiR ELOS** » Wed Jun 06, 2007 10:28 pm

Hi All,

New shooter, so be gentle... I have purchased an AICS 1.5 stock and wondering if anyone knows how to adjust the butt pad up or down.

If someone knows of this can be done, lets talk!

Ackley Improved · Post by **Ackley Improved** » Wed Jun 06, 2007 10:36 pm

I have one, just not here at moment. Getting rifle built using it so its at my smiths.

As far as I understand, the butt plate/pad only uses spacers, so it does not adjust up and down, just you can change the LOP.

If its the cheek piece, just two screws.

Cheers
AI

SiR ELOS · Post by **SiR ELOS** » Wed Jun 06, 2007 10:42 pm

Thanks. Reason being, Dewey cleaning rod hits the butt plate... No big one.

Ken L · Post by **Ken L** » Thu Jun 07, 2007 5:04 am

SiR ELOS wrote:Thanks. Reason being, Dewey cleaning rod hits the butt plate... No big one.

Cleanbore make a longer cleaning rod for these occasions that take the dewey brushes.
I have seen bores fail permaturely due to lifting the cleaning rod handle over the butt and causing wear on one side of the throat even when a bore guide was used.

SiR ELOS · Post by **SiR ELOS** » Sat Jun 16, 2007 11:01 pm

Thanks for all the reply's. All i need to do, is remove the top bolt and loosen the bottom bolt. This allows me to swing all butt plates out of the way for the cleaning rod. Eh, it works!

Simon C · Post by **Simon C** » Sun Jun 17, 2007 9:37 am

There u go!

THis character shot a pair of 58's yesterday at 600m un-coached in his second outing! :shock:

I think he is shifty....like me