OzFclass

Thank you all for the Feedback,
The Wilson dies look good.
I had a look at the Hornady 7mm/.284 seater die , it to looks good and looks like the 7mm seater die can do multiple 7mm cartridges so that's a win.
ill just keep using the standard 7-08 Redding seater die for now till I make my mind up, its just a little hard to keep the seating consistent and if i push just a little hard on the press it blows the Ackley shoulder out.
Thanks again.
Ryan

My apologies, I use a Redding 7-08 ai neck die . No bushing . Not sure which is best as I’ve used both FL and neck dies and both have performed!