OzFclass

Hi Folks,

I have a PSECO sleeved remington action that is glued into a fibreglass stock. I don't know what it is glued in with, nor do I know what the sleeve is glued on with.

To separate a glue in previously, I would just heat the action (hair dryer or clothes iron, usually) until the two came apart with a but of pressure on the barrel.

Any ideas how in the hell I might safely separate the two without destroying the stock, or ungluing the sleeve?

Anyone know what sort of glue sleeves are typically held on with?

I'm a little stuck for ideas on this one...

Alex

would it be worth contacting john giles?
keep safe,
bruce.

Hi
Try putting it in the beep freeze.
EWM

As Bruce said.

AS Bruce said
my guess would be JB epoxy resign
RB