Page 1 of 1

Newbie ammo question.

Posted: Tue Oct 07, 2008 4:16 pm
by Quick
Please forgive the complete newbie question that follows. What is velocity of the factory NRAA 155gr ammo that the NRAA gets cheap for us? I thought it could be around 2600fps but im not think its closer to the 2800fps mark. Can some one please help me. Its been nagging me for a few hours now and I can't seem to find it.

And can some one please tell me what it is loaded as, powder, etc.

Posted: Tue Oct 07, 2008 6:41 pm
by Simon C
I believe it gets around 2950fps in a 30" barrel. This is the generally accepted velocity most are searching for to shoot out to 1000yds.

Of course your barrel length will impact on this. I recall that every inch is worth about 70fps.

I'm sure others will be able to verify these numbers

Posted: Tue Oct 07, 2008 6:56 pm
by Quick
So is it faster as the barrel is shorter or slower? Isnt it the shorter, the faster the round travels.

Posted: Tue Oct 07, 2008 7:29 pm
by bully_eye
Generally velocity increases with longer barrels and gets slower with shorter.

Michael

Posted: Tue Oct 07, 2008 7:39 pm
by Quick
I thought it was the oppisite. Whats the twist rate on the standard Omark barrels.

Posted: Tue Oct 07, 2008 8:34 pm
by Simon C
Again, this would be a stab in the dark but I would say that they would be 1:12 or 1:13.

Velocity goes up with a longer barrel and drops with a shorter barrel. As I said, ~70fps per inch of barrel as a general guide.

Posted: Tue Oct 07, 2008 9:05 pm
by Quick
Ok then cheers guys.