Page 1 of 1
Where to get a WSSM/RSAUM stuck case remover.
Posted: Sun Apr 17, 2011 6:50 pm
by RDavies
Now that I will be using a WSSM case and others are already using RSAUM cases, it might be a good idea to get a stuck case remover to suit the bigger bolt face. Does anyone know who makes these?
I was thinking that every club has a 223 and 308 stuck case remover, but it will be a bit of a head ache if someone sticks a big case while on the mound at a big shoot.
Posted: Sun Apr 17, 2011 9:41 pm
by bruce moulds
rod,
as an interim measure perhaps a long series drill, a set of ezyouts, and a pair of needlenosed vicegrips might help.
bruce moulds.
Posted: Sun Apr 17, 2011 10:41 pm
by RDavies
I was after one of those slide hammer jobs to pull out loaded rounds when the extractor slips off the rim, not so much for when the case separates.
Posted: Mon Apr 18, 2011 6:11 am
by jcinsa
http://www.brownells.com/.aspx/pid=972/ ... ASE_PULLER
Is this what you were looking for ?
Hope it helps,
John
Posted: Mon Apr 18, 2011 8:29 am
by RDavies
Thanks JC, it was what I was after. I will order one soon.
Posted: Tue Apr 19, 2011 2:33 pm
by Matt P
Rod
What are you playing with now ????
Matt P
Posted: Tue Apr 19, 2011 5:14 pm
by RDavies
My new 6.5 OBR (obese BR) will be out soon. Otherwise known as a 6.5 WSSM, a necked up 25WSSM. It looks like a 6BR after being married for 10 years. It is balisticly the same as a 260AI with the bling factor (very important) of a short fat case.
A lot of others down South are switching to the longer RSAUM cases, so a few stuck case removers around might be handy as clubs wont have them on hand.