Page 1 of 1
Getting reamers re ground
Posted: Tue Oct 01, 2013 12:10 pm
by Brad Y
Anyone in oz re grinding finishing reamers? I want to make my 6.5mm a little shorter in freebore by about 40 thou. Not sure if I need to send it back to USA or not.
Cheers
Posted: Tue Oct 01, 2013 7:37 pm
by trxdick
I went through the exercise a while back to get a reamer reground also. I was recommended a local tool grinding service but he wasn't confident to get the precise angle and his quote was pricy. I sent it to PTG and they did it for about $50 including return post. Auspost to US was about $15. I think the turnaround time was about 6 weeks.
Posted: Tue Oct 01, 2013 8:06 pm
by bruce moulds
brad,
I had pt&g shorten the freebore on a 284 reamer no probs.
bruce.