OzFclass

Hi all having a 22br made up 1:8 twist krieger 30 inch going to run 80gr projectiles and adi powders. Any info would be helpful thanks.

PM sent

I've had good results with 80 grain VLDs 33.9 grains of 2209 and a cci450 primer it fills the case pretty well so work up to it

G'day all,
I'm running 31.2gn 2208, starting load was 29.5 could have gone higher but the accuracy was perfect. Krieger 28" Palma profile barrel that had accuracy nodes aat about 1 gn intervals which is mainly why I didn't load any higher than 31.2 Primer was CCI450, cases Lapua, neck turned, flash hole and primer pockets uniformed. First outing at a 300m mozzie match aggregate for all targets was 0.44moa, if flyers were missing it would have been a LOT smaller.
Hope this helps.
cheerio Ned

Ok thanks everybody what velocity are u getting with the 80gr projectiles?

G'day JMC,
based on real world elevation and then adjusting MV in Sierra Infinity V6 Ballistic software about 3200 fps which is about right out to 500m.
Cheerio Geoff