OzFclass

Does anyone know if the Wilson 6.5x284 neck dies have a wide enough neck to neck size a straight 284 with the right sized bushing? BRT list the die as a 6/6.5-284, whereas I've seen what appears to be the same die listed as a 6mm-284/6.5mm-284/284 Winchester on international sites.

Anyone using one?

I'm sizing my .30/284 necks with one ( I have .004" on my turned necks), so 7 mm is a shoe in.

johnk wrote:I'm sizing my .30/284 necks with one ( I have .004" on my turned necks), so 7 mm is a shoe in.

Thank you, John - exactly what I needed to know