Page 1 of 1
Barnard fit an Musgrave inletted Don Brooks Stock
Posted: Thu Dec 29, 2016 5:54 pm
by Wayne_tri62
Greetings all
Quick question on action fitting. Would a Barnard Action fit easily into a Don Brooks aluminum stock, that is currently in-letted for a Musgrave Action. Current barrel is MAB 30 inche'er..
Would there be any real problems.
Thanks
Re: Barnard fit an Musgrave inletted Don Brooks Stock
Posted: Thu Dec 29, 2016 6:50 pm
by Barry Davies
Wayne,
It would not be a straight forward job as the Musgrave is a flat bottom receiver whereas the Barnard is round.
Without seeing the stock I would guess it could probably be machined out and a Barnard V Block fixed in.
Bolt handle may be in a different position relative, as with the trigger and T/D screws
Re: Barnard fit an Musgrave inletted Don Brooks Stock
Posted: Thu Dec 29, 2016 10:08 pm
by Wayne_tri62
Sir...
Thanks heaps for your input,,,
I was looking at a budget alternative,,,
thanks again and Happy New Year