Page 1 of 1
to taper the flash hole or not ?
Posted: Wed Aug 09, 2017 8:47 pm
by lonerider43
as per the title.
do you taper the flash hole or not ?
inside and or out.
is it beneficial ?
thoughts ?
sean
Re: to taper the flash hole or not ?
Posted: Wed Aug 09, 2017 8:58 pm
by johnk
Never seen a problem with the primer pocket side of a flash hole (some 375/2½ Bertram excepted) but there are occasions when it might be desirable to knock dags of punched flash holes on the inside of the case.
Re: to taper the flash hole or not ?
Posted: Thu Aug 10, 2017 4:02 pm
by Longranger
According to the latest from Bryan Litz, on Lapua brass don't touch the flash hole. Unify depth only.
Re: to taper the flash hole or not ?
Posted: Thu Aug 10, 2017 6:25 pm
by KHGS
Longranger wrote:According to the latest from Bryan Litz, on Lapua brass don't touch the flash hole. Unify depth only.
Norma brass should also be included with Lapua.
Keith H.