Hi,
Does anyone happen to know the outside neck diameter of a ADI/OSA 308 loaded cartridge?
Just wondering what bushing I will need for a Redding sizing die using ADI brass.
Thanks in advance Allan
ADI 308 Brass Redding Bushing Insert
Moderator: Mod
-
- Posts: 73
- Joined: Tue Feb 14, 2012 7:20 pm
Re: ADI 308 Brass Redding Bushing Insert
I bought a bag of 120 just before the lockdown as back up due to the component shortage.
I measured the o/d of a few of the loaded rounds to check whether they would fit my chamber with a .340 neck, the neck clearance is a little less than my usual 0.004 but they chambered (and fired) ok with an o/d averaging 0.3375.
I would use a 0.336 bushing but prefer a Lee Collet die unless neck turned.
I measured the o/d of a few of the loaded rounds to check whether they would fit my chamber with a .340 neck, the neck clearance is a little less than my usual 0.004 but they chambered (and fired) ok with an o/d averaging 0.3375.
I would use a 0.336 bushing but prefer a Lee Collet die unless neck turned.
-
- Posts: 3
- Joined: Sat Jun 05, 2021 4:20 pm
Re: ADI 308 Brass Redding Bushing Insert
NDOliver wrote:I bought a bag of 120 just before the lockdown as back up due to the component shortage.
I measured the o/d of a few of the loaded rounds to check whether they would fit my chamber with a .340 neck, the neck clearance is a little less than my usual 0.004 but they chambered (and fired) ok with an o/d averaging 0.3375.
I would use a 0.336 bushing but prefer a Lee Collet die unless neck turned.
Brilliant, exactly what I was after. Thankyou.
Return to “Equipment & Technical”
Who is online
Users browsing this forum: JezL and 46 guests