The slot is offset, could be inside case deburrer.
If so, what brand tool do they fit?
What do they fit?
Moderator: Mod
-
- Posts: 598
- Joined: Mon Nov 14, 2005 12:48 pm
-
- Posts: 883
- Joined: Fri Jun 17, 2005 12:15 pm
- Location: Innisfail, Far North QLD.
Re: What do they fit?
I never thought they were intended to fit any tool but to be used hand held. They do work OK hand held both inside and outside but are not as good as the other fluted type deburrer.
-
- Posts: 1526
- Joined: Wed Nov 09, 2011 7:00 pm
- Location: Sunshine Coast, QLD
Re: What do they fit?
I have one from when I started reloading. Pretty certain they are Lyman brand. They don't fit any tool. They are a chamfer and deburr tool used in your finger tips, hence the knurling. Only takes about 3 cases before your knuckles are locked up solid and you cant feel your finger tips anymore.
-
- Posts: 544
- Joined: Sun Feb 24, 2019 2:33 pm
- Location: Chinchilla
Re: What do they fit?
Lee chamfer/deburrer they do work somewhat, I have one, I also have a Wilson, I don’t use the Lee
-
- Posts: 186
- Joined: Fri Jun 16, 2006 10:01 pm
- Location: Bribie Island QLD
Re: What do they fit?
chamfer & deburing tool that come with every press kit made by Lee Precision.
heres an extra tip/use for them too.. they also work well to clean up a damaged thread on nuts and bolts if you"ve dropped them on concrete or similar .
heres an extra tip/use for them too.. they also work well to clean up a damaged thread on nuts and bolts if you"ve dropped them on concrete or similar .
Stiller/holeshot .22LR
Bruno mod2(sleeved) .22LR
Rem7(sleeved) 6mmBR and 6mm Dasher
Stolle panda 6PPC
Winchester 101 12g
Bruno mod2(sleeved) .22LR
Rem7(sleeved) 6mmBR and 6mm Dasher
Stolle panda 6PPC
Winchester 101 12g
-
- Posts: 624
- Joined: Mon May 08, 2006 5:34 pm
- Location: JUNEE NSW
-
- Posts: 22
- Joined: Fri Sep 07, 2007 5:15 pm
- Location: Sydney
Re: What do they fit?
They work well in conjunction with the Lee case trim tool that provides a case holder that fits in a cordless drill. Trim the cases to length and then use the chamfer tool to quickly trim the inside and outside of the case mouth.
-
- Posts: 935
- Joined: Thu Oct 20, 2005 12:46 am
- Location: Cowra NSW
Re: What do they fit?
Rich4 wrote:Lee chamfer/deburrer they do work somewhat, I have one, I also have a Wilson, I don’t use the Lee
You are correct, not one of Lee's better tools.
Keith H.
-
- Posts: 598
- Joined: Mon Nov 14, 2005 12:48 pm
-
- Posts: 883
- Joined: Fri Jun 17, 2005 12:15 pm
- Location: Innisfail, Far North QLD.
Re: What do they fit?
One of my early acquisitions was a Hornady reloading 'kit' although I did have a good old Aussie press. I am fairly sure one of these came in the kit.
Peter Smith.
Peter Smith.
Return to “Equipment & Technical”
Who is online
Users browsing this forum: CJO74 and 24 guests