Might be a good chance to lay out the procedure for any novice brass preppers.
Buy quality brass.
Weight sort brass.
Chamber neck minus 3 thou minus bullet dia - left over divided by 2 - that’s the target neck wall thickness.
I size brass then use an internal neck mandrel to expand for the neck turning tool.
Trim to suit with a drop of cutting fluid.(more detail here)
I do mine in one pass with a K&M with a big handle using a chord less screw gun.
Wash cases in shellite.
I also use an internal primer bevel
Clean up primer pockets
Fire cases, trim to length, bevel inside and outside of necks.
You can probably sense the air of excitement building for me anticipating my next 500 cases
![Very Happy :D](./images/smilies/icon_biggrin.gif)
If you had the joy of turning 500 cases what would you do?