Hi am full length sizing some 6.5 Peterson Brass after mandriling up from 6.5 to 7mm with a .309 bush i am using a foster press and a wilson die and my brass overall length is 2.155 in .284 W
however only about 2mm of the brass is touching the bush and the die is bottoming out, any help appreciated .
Wilson Die Question
Moderator: Mod
-
- Posts: 612
- Joined: Tue Oct 16, 2018 5:20 pm
- Location: 7321 Tas.
Re: Wilson Die Question
Your bush is floating, you need to tighten down the top nut, but not so it locks up. Just back it off 1/2 a turn or so
Pete
Pete
-
- Posts: 337
- Joined: Wed Aug 19, 2015 9:32 am
-
- Posts: 612
- Joined: Tue Oct 16, 2018 5:20 pm
- Location: 7321 Tas.
Re: Wilson Die Question
Is the bush the right way up, it only sizes on one end . writing should be up
-
- Posts: 337
- Joined: Wed Aug 19, 2015 9:32 am
-
- Posts: 612
- Joined: Tue Oct 16, 2018 5:20 pm
- Location: 7321 Tas.
-
- Posts: 337
- Joined: Wed Aug 19, 2015 9:32 am
-
- Posts: 7502
- Joined: Wed Jun 15, 2005 8:22 pm
- Location: Maffra, Vic
Re: Wilson Die Question
Has the Wilson die been used successfully with other brass? If not, is it a factory die or one made with a die blank and reamer. If the latter, then maybe the reamer needs to go deeper? (or the die base shortened, or both).
-
- Posts: 337
- Joined: Wed Aug 19, 2015 9:32 am
Re: Wilson Die Question
Hi Thanks for your help but I have just worked out the problem .......I hade removed the decapping pin and found out the black knurled nut not only holds the decapping pin in but also pushed the bushing into its final position.'......user error and no one to blame hahha
Return to “Equipment & Technical”
Who is online
Users browsing this forum: No registered users and 25 guests