Vee block bedding to stock

Wattorjw · Post by **Wattorjw** » Fri Feb 18, 2022 7:59 am

I want to bed a barnard action to a laminated stock any suggestions with resin /glue type would help thanks

Rich4 · Post by **Rich4** » Fri Feb 18, 2022 1:01 pm

I’ve had good results with devcon 10110 steel putty, also the aluminium putty was fine too

Dicko · Post by **Dicko** » Fri Feb 18, 2022 5:17 pm

Hey Bob,
Check your PM I've sent you the info.

Crash Test Dummy · Post by **Crash Test Dummy** » Sun Mar 27, 2022 11:57 am

Hi guys
I am trying to find out same info. Very little out there. Any help would be really appreciated.

Cheers

Old Trev-39 · Post by **Old Trev-39** » Sun Mar 27, 2022 7:14 pm

I use Epiglue. It is a 2 pack marine grade epoxy.
Cheers,
Trevor.

Charlie · Post by **Charlie** » Wed Apr 27, 2022 10:30 am

What’s the correct way to bed an RPA Quadlock. I’m fitting it into McMillan FClass stock.

Bigtravoz · Post by **Bigtravoz** » Fri May 27, 2022 8:24 pm

Charlie wrote:What’s the correct way to bed an RPA Quadlock. I’m fitting it into McMillan FClass stock.

JB weld or you can get acraglass or the other one that I can’t remember the name of at the moment.

Bigtravoz · Post by **Bigtravoz** » Fri May 27, 2022 8:30 pm

Armagrout was the one my alzheimers couldn’t remember.