Omark Remington 700 trigger
Moderator: Mod
-
- Posts: 1
- Joined: Wed Jun 30, 2021 9:31 pm
Omark Remington 700 trigger
Hi guys. I'm new to f class. Is a Remington 700 Timney trigger a straight drop in for an Omark 44 or are there modifications required. Thanks
-
- Posts: 430
- Joined: Mon Oct 29, 2012 9:11 pm
Re: Omark Remington 700 trigger
You need to modify the cocking piece in 1 or 2 ways .
Dependent on when your omark was built will determine if it has a square of angled cocking piece .
If angled you follow the same angle and file it back carefully until the timing is correct .
If it is square you need to set the angle to match and then time the action .
Before people say this can’t be done please see attached image .
That is a Remington 700 trigger that has been modified to be a 3 lever “Remington 2oz” trigger .
Dependent on when your omark was built will determine if it has a square of angled cocking piece .
If angled you follow the same angle and file it back carefully until the timing is correct .
If it is square you need to set the angle to match and then time the action .
Before people say this can’t be done please see attached image .
That is a Remington 700 trigger that has been modified to be a 3 lever “Remington 2oz” trigger .
You do not have the required permissions to view the files attached to this post.
-
- Posts: 12
- Joined: Thu Oct 19, 2017 6:24 pm
Re: Omark Remington 700 trigger
I’m glad you asked this question Roman. This is the plan I have for my Omark as well. Cheers
-
- Posts: 162
- Joined: Thu Feb 25, 2016 11:07 am
- Location: Qld
Re: Omark Remington 700 trigger
before going to far with omarks make sure your bolt head retainer pin is large pin or else most ranges will not allow it on range
-
- Posts: 266
- Joined: Mon Mar 18, 2013 4:21 pm
- Location: Waikato NZ (Ex Tyabb)
Re: Omark Remington 700 trigger
20 years ago I fitted a Shilen 2oz trigger to my Omark. It was a "drop in" no mods required.
With a trigger weight rule change I changed to a Jewell. With this I had to file the cocking piece back. Mine is the angled version. A bit of a nervous job. File a bit, try, file a bit, try.
I rehardened the cocking piece once I had correct timing.
With a trigger weight rule change I changed to a Jewell. With this I had to file the cocking piece back. Mine is the angled version. A bit of a nervous job. File a bit, try, file a bit, try.
I rehardened the cocking piece once I had correct timing.
Return to “Equipment & Technical”
Who is online
Users browsing this forum: No registered users and 97 guests