155g Hybrid projectiles ?
Moderator: Mod
-
- Posts: 563
- Joined: Sun Jan 12, 2014 10:00 pm
- Location: Cairns QLD
I have not Chrono'd, the time of flight from the et shows about 100mS quicker for the hybrids, they are about three minutes better on elevation, just not grouping.
The only config so far that showed promise was ten thou jam soft seated (only neck sized the first 2mm of the neck). Not a configuration I'd like to take to a queens or prize meet, just incase I had to unload a live round.
I will put the hybrids in the back of my ammo safe and try again with the next barrel.
The only config so far that showed promise was ten thou jam soft seated (only neck sized the first 2mm of the neck). Not a configuration I'd like to take to a queens or prize meet, just incase I had to unload a live round.
I will put the hybrids in the back of my ammo safe and try again with the next barrel.
-
- Posts: 1453
- Joined: Mon Aug 22, 2011 6:33 pm
Josh,
sounds like a smart move. We often say "let the barrel do the talking" - if it likes Noslers, feed it Noslers. I believe you have the HBC working well also? These will probably make 1000 yards much better if you are shooting longs but by the looks of your scores and elevation spread at 800m with the Noslers it is hard to go past them. Many Shooters only dream of half minute at 800m so it is all good - load and enjoy.
sounds like a smart move. We often say "let the barrel do the talking" - if it likes Noslers, feed it Noslers. I believe you have the HBC working well also? These will probably make 1000 yards much better if you are shooting longs but by the looks of your scores and elevation spread at 800m with the Noslers it is hard to go past them. Many Shooters only dream of half minute at 800m so it is all good - load and enjoy.
-
- Posts: 2181
- Joined: Fri Jun 26, 2009 8:21 pm
The hybrids are a very appealing bullet to the shooter, with great BC's and a "seating depth insensitive" reputation. However I have found them a little finicky to get right. Often they are near on good enough but not quite 'there' and it takes alot of fine tuning (barrel life and lots of projectiles) to get them exactly right.
In 6.5mm I tried them over the VLD because I wanted to jump projectiles not jam them. It worked out that they shot best with a jam and VLD's shot the same POI (jagged that dunno how) at 900m with the same jam. Ive gone to VLD's as they are cheaper and the BC difference is practically nothing.
In 6mm, I did alot of research as there are rumoured fat and skinny batches of the 105 hybrid. In the dasher I decided that I would start testing with a 50 thou jump on my 'fat' projectiles and possibly go to 60 thou. I havent done any seating depth testing as they are holding the X ring beautifully. Again lucky with them. However Im looking at other projectiles that are a little more consistent in dimension for 1000ydBR which is ultimately what I built the dasher for. VLD's will be my next projectile to try, as will be lapua scenars and 103 copperheads.
In 7mm, Again I found they need alot of work. Got some good groups in the short ranges but they were a little hollow at longer ranges. The VLD's just worked straight up with the 10 thou jam. There is a difference in BC which is probably worth trying a bit more to get them to work, but for now I just need my 7mm working and not being used as a test barrel. Once I get a new barrel I will revisit what I shoot in it- the BC on them is great and they are able to get a good gain from pointing as well. I never tried them jammed in my rifle but persisted for so long with them jumped. Even though I diagnosed my problem as a loose scope rail, the VLD's just shot tighter.
End of the day accuracy reigns supreme and despite what we think we might lose with BC advantage we really do make up with having confidence in a rifle. Knowing its going to hold x ring waterline when its windy and being capable of 60's with high x counts is what matters when its calm. I recommend Daves advice- feed that gun what it likes and enjoy the shooting.
In 6.5mm I tried them over the VLD because I wanted to jump projectiles not jam them. It worked out that they shot best with a jam and VLD's shot the same POI (jagged that dunno how) at 900m with the same jam. Ive gone to VLD's as they are cheaper and the BC difference is practically nothing.
In 6mm, I did alot of research as there are rumoured fat and skinny batches of the 105 hybrid. In the dasher I decided that I would start testing with a 50 thou jump on my 'fat' projectiles and possibly go to 60 thou. I havent done any seating depth testing as they are holding the X ring beautifully. Again lucky with them. However Im looking at other projectiles that are a little more consistent in dimension for 1000ydBR which is ultimately what I built the dasher for. VLD's will be my next projectile to try, as will be lapua scenars and 103 copperheads.
In 7mm, Again I found they need alot of work. Got some good groups in the short ranges but they were a little hollow at longer ranges. The VLD's just worked straight up with the 10 thou jam. There is a difference in BC which is probably worth trying a bit more to get them to work, but for now I just need my 7mm working and not being used as a test barrel. Once I get a new barrel I will revisit what I shoot in it- the BC on them is great and they are able to get a good gain from pointing as well. I never tried them jammed in my rifle but persisted for so long with them jumped. Even though I diagnosed my problem as a loose scope rail, the VLD's just shot tighter.
End of the day accuracy reigns supreme and despite what we think we might lose with BC advantage we really do make up with having confidence in a rifle. Knowing its going to hold x ring waterline when its windy and being capable of 60's with high x counts is what matters when its calm. I recommend Daves advice- feed that gun what it likes and enjoy the shooting.
Return to “Equipment & Technical”
Who is online
Users browsing this forum: No registered users and 91 guests