Got my reamer now for my 6.5mm project.
Starting to look around for dies and since its a wildcat there arent any standard dies available here just wondering if its possible to use a 260 case with 30 degree shoulder in a 6.5x47L body die or if I should look at a standard or AI 260 body die.
Body die
Moderator: Mod
-
- Posts: 153
- Joined: Mon Jul 24, 2006 12:10 am
- Location: Hervey Bay Qld
-
- Posts: 2181
- Joined: Fri Jun 26, 2009 8:21 pm
-
- Posts: 153
- Joined: Mon Jul 24, 2006 12:10 am
- Location: Hervey Bay Qld
The standard 260die wont work due to the shoulder angle but I am pretty certain that Redding make a 260 Imp 30 degree shoulder die set. Should be readily available from Sinclairs or you could use the 243 Imp with 30 degree shoulder and just have the neck reamed out to suit.
Peter Van Muers at Pro Cal may even have something on hand.
Peter Van Muers at Pro Cal may even have something on hand.
-
- Posts: 2181
- Joined: Fri Jun 26, 2009 8:21 pm
Yeh thats why I wanted to check. So it would fit in the standard body die (I already have a 308 so that will work) the only thing is will it bump the shoulder/body down or will it do nothing at all.
Been trying to buy a type S FL die for this exact round from Robert Whitley in USA but I dont know if my emails are getting through.
Neck sizing can be done with a collet die and seating with a standard seater.
Been trying to buy a type S FL die for this exact round from Robert Whitley in USA but I dont know if my emails are getting through.
Neck sizing can be done with a collet die and seating with a standard seater.
-
- Posts: 1193
- Joined: Tue Jun 03, 2008 11:30 am
- Location: Adelaide
His phone number is given at the top of the page. Why not give him a call?
http://www.6mmar.com/260_Imp_30_.php
Ian
http://www.6mmar.com/260_Imp_30_.php
Ian
Return to “Equipment & Technical”
Who is online
Users browsing this forum: No registered users and 102 guests