284 neck size
Moderator: Mod
-
- Posts: 463
- Joined: Tue May 14, 2013 8:16 pm
- Location: Gippsland Victoria.
284 neck size
For a 284 or 284 shehane what neck size reamer should I be looking for? I noticed on the SA F Class interview with Bill Shehane that he recommends a no turn neck of .318. A gunsmith I am looking at has a reamer with a .312 neck which sounds pretty tight. I would prefer not to have to neck turn if possible. Any advice or suggestions from those here that know?
-
- Posts: 2181
- Joined: Fri Jun 26, 2009 8:21 pm
Un turned brass loaded is about .313" and most reamers tend to be that size so turning is needed. Mine is .318" but I havent had any joy out of this barrel, so cant say if the .318" neck and .220" freebore is a good combo. I believe it will be.
Just remember you will get donuts in 6.5x284 brass necked up and if you run a no turn chamber you might want to look at a .235" freebore and only sizing the top half the neck to avoid them affecting your loads. Otherwise your up for inside neck reaming. Turning would probably be a safer option. You can run the expander mandrel in anytime to push the donut to the outside of the neck and turn it off. If I did it again, I would get a .315" neck just so I didnt need to turn as much but still clean up the necks and get the required clearance. Anytime necking up or down I think turning is a good idea to make sure everything is right.
Just remember you will get donuts in 6.5x284 brass necked up and if you run a no turn chamber you might want to look at a .235" freebore and only sizing the top half the neck to avoid them affecting your loads. Otherwise your up for inside neck reaming. Turning would probably be a safer option. You can run the expander mandrel in anytime to push the donut to the outside of the neck and turn it off. If I did it again, I would get a .315" neck just so I didnt need to turn as much but still clean up the necks and get the required clearance. Anytime necking up or down I think turning is a good idea to make sure everything is right.
Return to “Equipment & Technical”
Who is online
Users browsing this forum: No registered users and 106 guests