Copperhead projectile approval?

Get or give advice on equipment, reloading and other technical issues.

Moderator: Mod

Message
Author
lonerider43
Posts: 190
Joined: Thu Sep 01, 2016 6:55 pm

Re: Copperhead projectile approval?

#16 Postby lonerider43 » Sat Aug 11, 2018 5:32 pm

Ammunition components and powder need not be sourced solely from the NRAA

For F Open Division – Projectiles Allowed
Any weight or calibre of projectile provided it does not exceed 8 mm in diameter.

this is where i got confused i think.
Australian's Against "Gun-A-Phobia"

Ken Melgaard
Posts: 60
Joined: Fri Jul 01, 2005 7:32 pm
Location: West Wodonga, Vic

Re: Copperhead projectile approval?

#17 Postby Ken Melgaard » Tue Aug 14, 2018 7:27 pm

Yes.... the NRAA
Sent 500 of my 224 caliber 80 grain VLD to the NRAA about 7-8 years ago am still waiting for a response!! Dont know what ever happen to them or even if they bothered tested them.
I think the NRAA Board menbers are there to look after themselves, you only have to look at JLK bullets it was only the fact that Jan Dyer was on the board and Bob Dyer imported them that they got excepted a good example of the boards infuence on what the members use!!
Have no problems suppling bullets they just need to accepted “ Copperhead Bulletsl
Cheers
Ken Melgaard
Copperhead Bullets

KHGS
Posts: 598
Joined: Thu Oct 20, 2005 12:46 am
Location: Cowra NSW
Contact:

Re: Copperhead projectile approval?

#18 Postby KHGS » Tue Aug 14, 2018 10:29 pm

As the NRAA gunsmith at that time I tested & reported on these bullets along with the JLK bullets. My report recommended the approval of Ken's bullets on the basis of quality & being Australian made. I never had any response to my recommendation. Consequently the JLK's were approved .........for whatever reason!!!!
Keith H.


Return to “Equipment & Technical”

Who is online

Users browsing this forum: No registered users and 7 guests