[quoteI think there is more to be gained by experimenting with the anchoring, weight and geometry of the rear bag.
Peter Smith.][/quote]
Peter, this agrees with Harry Pope's discoveries early last century and is correct. Alan would have to push for a rule change to take the sand out of the bags if it was taken to the extreme. Brad might be sniffing in the right area too, but he might need a flat hard rear bag. David.
Im happy to be corrected, but from what I understand, people that have spoken to (Dave and Alan) have tried offset stocks are now back using straight stocks that focus more on low centre of gravity.
I have an offset fore end on a stock Im using. Its on a 6 dasher and is only there because the stock was already made that way before I reset it up to use with this barrelled action and I cant be bothered changing it with a new rifle on the way. The new rifle WONT have an offset fore end, but will have a low center of gravity and have a fairly long 'wheelbase' to start with and adjustable weights in the butt so I can work out what suits in regard to getting the best balance, tracking and overall handling set up that I can get.
Im reminded of a club shoot we had last year where 'Quick' aka Shaun Stoffels pointed out while watching me shoot, I did have an issue with the stock jumping around on my 7mm. I believe that was due to it either not fitting me correctly and/or a rear bag that wasnt suitable for the stock either.
Have recently 'renovated' a front rest with a quality top that you can adjust bag tension with properly and a purposely built bag that goes with it- and the difference in tracking is unreal. Importantly, its also pimped out for any potential south oz trips. A big solid, flat and stable rear bag with plenty of support in the ears to guide the stock back straight and not twist/jump/lift is my next acquisition to try out.
FWIW and it might echo everything that has been already said, but I think the whole setup with a proper fitting stock, balanced rifle, comfortable position and consistent technique on reliably stable rear and front rests is the key to shooting. Its that bloody wind reading stuff that can be worried about after everything else is sorted out.
OK - thanks to all who have taken the time to have an input into this question. There is nothing better than getting this sort of feed from those who have already tried it and decided against it. This will save me a lot of work now. Conclusion is: No offset stock, organize stock to be as low as possible and work on bag set-ups and balance of rifle. Had always planned to cut it as low as possible BUT with some sort of offset built in to help. You guys collectively have now changed my mind.
David.
Menu
Newest members