Hi guys.
Looking for a rough start point for 168 vld 7mm Bergers in a straight 284. 28 inch parallel barrel 1:9 twist. Anyone running these, looking to preserve my stash of 180/184 so will run the 168vlds at my local range.
Cheers
Ray
Load data 168 vld in 284
Moderator: Mod
-
Ray Hurley
- Posts: 30
- Joined: Mon May 11, 2015 8:52 pm
- Has thanked: 3 times
- Been thanked: 3 times
Re: Load data 168 vld in 284
G'Day Ray,
Yes, I'm running these. Loading 51 grains of 2209 with PMC primers.
Regards............Greg Warrian.
Yes, I'm running these. Loading 51 grains of 2209 with PMC primers.
Regards............Greg Warrian.
-
Ray Hurley
- Posts: 30
- Joined: Mon May 11, 2015 8:52 pm
- Has thanked: 3 times
- Been thanked: 3 times
Re: Load data 168 vld in 284
Hey Greg.
Thank you for the reply. What muzzle velocities should I be expecting to see.
Ray
Thank you for the reply. What muzzle velocities should I be expecting to see.
Ray
Re: Load data 168 vld in 284
Hey mate, I think I was around 52 in the shehane from memory. Was all I used at short ranges for a while. Plodding along around 2900. I would say start at 50 and work up knowing current powder seems faster than the older stuff. Jammed 10 seemed to work fine.
-
Ray Hurley
- Posts: 30
- Joined: Mon May 11, 2015 8:52 pm
- Has thanked: 3 times
- Been thanked: 3 times
-
pveng
- Posts: 21
- Joined: Fri Aug 05, 2022 11:08 am
Re: Load data 168 vld in 284
Info is available below
http://www.adiworldclass.com.au/data-ri ... winchester
http://www.adiworldclass.com.au/data-ri ... winchester
Re: Load data 168 vld in 284
G'Day Ray,
I haven't checked, but I would expect about 2870-2880.
Greg W.
I haven't checked, but I would expect about 2870-2880.
Greg W.
-
Joah555
- Posts: 22
- Joined: Mon Jun 28, 2021 2:01 pm
Re: Load data 168 vld in 284
Hi Ray, i load 51gn 2209, 32" 1:9 twist barrel with about 1450 rounds through it. 2902fps
You do not have the required permissions to view the files attached to this post.
Menu
Newest members